Double-tap and hold to zoom.

Mouse over the image to zoom.

TRIM TAB ACTUATOR ASSEMBLY

Product Code: BENA1101A

Complete replacement cylinder for Bennett stabilizer system made of tough nylon / fiberglass.
Closed length 13¾ "(34.93 cm) Bottom hinge (BENA-1113) and pin (BENA1115) included.
Bennett actuators are built to last, maintenance-free, and enjoy the legendary support and legendary lifetime warranty from Bennett Marine.
The piston-shaped arms push the tabs into position.
All models offer a 2.5 "stroke. Replacement actuators do not include hardware.
The H1170A hardware kit is recommended when replacing a hydraulic actuator assembly.
Compact powerhouse that creates hydraulic pressure to lower and raise the trim tabs
Employs two solenoid valves to direct the flow of fluid to the actuators
Solenoid valves lock tightly to secure the tabs in place
Lexan cover protects electrohydraulic unit from occasional wash down and translucent reservoir allows fluid check at a glance
24 Volt power

roller shaft 5 / 8x19 w / grease

RELEASE PINCHER